
Plastic deformation of the piston in the running-in phase
Information on the product
How do you measure the piston diameter? In the event of which deviations can it no longer be used? What can you do if there is no measuring window present on the piston? What is a skirt failure on a piston? This article shows the solutions.
During the first hours of operation new pistons are subjected to permanent plastic deformation. On most pistons, the piston diameter is reduced by a few ¹⁄₁₀₀ mm. This process is referred to as skirt failure.
Technical background
The skirt failure is caused by thermal and mechanical strain on the piston during the first warm-up phase. The reduction of the piston diameter (Dmax ) is different depending on the model, material composition and specific stress of the piston.
What this means in practice
The piston diameter of new pistons must be measured and recorded before installation. If the measured value deviates from the nominal piston diameter stamped on the piston, the piston cannot be used. Thanks to the plastic deformation when runningin, the original piston diameter can no longer be determined for pistons that have been run in. Complaints relating to the nominal piston diameter can no longer be made for pistons that have been run in.
Measuring the piston diameter
The maximum piston size (Dmax ) is located in the lower third of the skirt area. Pistons with skirt coatings often have so-called “measuring windows” within the coating. The maximum piston size is calculated at the lower measuring window (Fig. 1).
![]() |
NOTE In order to avoid measuring errors, the measuring surfaces of the measuring tool (outside micrometer) cannot be larger than the measuring windows in the coating. |
If there are no measuring windows on a coated piston skirt, the piston diameter must be measured directly on the coating. Tocalculate the exact piston diameter, the double coating thickness (approx. 2 × 0.015 mm) must be subtracted from the measured value. If the position of the maximum piston size on the piston skirt is not known (piston coating with no measuring windows, uncoated piston), the exact position must be calculated by means of multiple measurements (90° to the centreline of piston pin).